Danubius International Conferences, 16th International Conference on European Integration - Realities and Perspectives
Analyzing Surface Roughness of an Auto-truck Cylinder after Several Running Hours
Last modified: 2021-05-12
Abstract
Our paper aims to present the measuring process and results regarding roughness of the inner surface of a truck cylinder, according to standard [6]. To that purpose, it was used a Surtronic S-Series roughness tester, with a stylus able to measure within the range 400 µm. According to the before-mentioned standard, there were performed 4 measurements on the same circular line, each one shifted by 90 degrees to the previous. The process was repeated on eight functional areas characteristic to the cylinder (entire length was divided into eight equal parts). With the use of measured values it was possible to analyze whether the cylinder's inner surface had proper roughness according to specific standards, even after several functioning cycles.
Acknowledgments: This work is supported by the project “ANTREPRENORDOC”, in the framework of Human Resources Development Operational Programme 2014-2020, financed from the European Social Fund under the contract number 36355/23.05.2019 HRD OP /380/6/13 – SMIS Code: 123847.
